ADE Cecile Instruction Manual page 8

5. Programming / Enter of personal data
Before first time use your personal data like gender (female or male, sports or no
sports), body height and age must be programmed and saved under selected
locations 1 – 4 (up to 4 persons). The enter keys are located at the head front of the
scale. To enter your personal data please utilise the buttons: SET (on and save
‚ 
button), (plus button), (minus button) and follow the particular points:
1. Press the SET-button. The display indicates a
flashing "1". To select your personal location
(1 - 4) press the  or ‚ button. After the selection
of your personal location press the SET-button to
save the reading.
2. After you've selected your personal location
(e.g. 3) the symbol for gender starts to flash.
To select the requested gender ( male,
or male sports, female sports), press the
 or ‚ button. After the selection of your gender
press the SET-button to save the reading.
3. After you've selected your gender (e.g. female)
the symbol for body height starts to flash (default
165 cm). To enter your height press the  or ‚
button. After the selection for your height press
the SET-button to save the reading.
4. After you've selected your body height the symbol
for age starts to flash (default 30 age). To enter
your age press the  or ‚ button. After the
selection of your age press the SET-button to save
the reading.
After input completion the display indicates "0.0 kg". After a few seconds the scale
automatically powers off.
To enter personal data of further persons please repeat the steps listed below.
6. Weighing function (weight measurement only)
1. Switch on the scale by using the step-on-function. Just step on the scale. Remain
stationary on the weighing platform and do not hold you tight. After a few seconds
your weight will be displayed.
165
l
165
female,
3
165
3
30
3
4
2. After weighing step off the scale. The scale will switch off automatically after a few
seconds.
3. If you remain over on the weighing platform the analyser scale automatically switch
into the measuring mode and starts the body analysing.
7. Body Analysis
An analysis is only possible in bare feet. Your personal data must be entered first
cm
(please see page 4).
1. Press the SET-button and select your personal location by using  or ‚ button.
2. As soon as "0.0" appears on the display the scales is prepared for the measurement.
cm 3. Carefully step on the stainless steel flags of the scale in bare feet and remain
stationary while the measurement is now taking place.
4. At first your weight will be indicated on the display. Shortly after, while the analysis is
taking place, the signals "o" starts to move. After completion of the measurement
your measured values will be shown as follows:
cm
1. Your body fat % and as subtitle an evaluation: Under fat / Healthy / Over fat /
Obese
2. Your body water %
3. Your muscle mass %
Afterwards your measured values (weight, body fat, body water and muscle mass) will
be shown in changes successively 3 times.
EXAMPLE:
age
54.0
3
Weight
When you once used the scale you will be able to get the readings of your last
measurement. This function allows you to follow the changes between your
measurements. For that press the  or ‚ button and choose your personal location.
Now the display indicates in changes successively the measured values of your last
measurement.
24.0 51.0
fat
TBW
%
kg
3 3
Healthy
Body Fat Body Water
5
31.5
MUS
%
%
3
Muscle Mass