Dell Wyse 3040 Thin Client User Manual page 34

2. Bridged connections — The number of bonded connections that are set up are listed here. To add a new bond
connection, click the Add button and select the type of connection you want to create. The available options are
Ethernet, Wi-Fi, and VLAN.
3. Aging time — Enter the Aging time duration in seconds.
4. Enable STP — Select this check box to enable the Spanning Tree Protocol (STP) for your connection.
5. Priority — Enter the priority value.
6. Forward delay — Enter the forward delay duration in seconds.
7. Hello time — Enter the hello time duration in seconds.
8. Max age — Enter the value for the maximum age.
b. To configure the General tab, IPv4 Settings tab, and IPv6 Settings tab for Bridge connection, see the configuration details
for Bond connection in this section.
5. Configure the VLAN network connection for your thin client.
a. Click the VLAN tab, and configure the following options:
1. Parent interface — Type the name for your parent interface.
2. VLAN id — Enter the value for the VLAN id.
3. VLAN interface name — Type the name for your VLAN interface.
4. Cloned MAC address — Type the cloned MAC address.
5. MTU —Specifies the size (in bytes) of the largest protocol data unit that the protocol layer can pass onwards.
b. To configure the General tab, IPv4 Settings tab, and IPv6 Settings tab for VLAN connection, see the configuration details
for Bond connection in this section.
6. Click Save to save your settings.
Configuring peripherals settings on Wyse ThinLinux
On the System Settings page, click the Peripherals icon. The following tabs are displayed on the left pane of the System Settings
page.
• Keyboard
• Mouse
• Printers
• Sound
Setting the keyboard preferences
The Keyboard setting page enables you to set the Keyboard preferences and make the Keyboard layout.
NOTE: By default, the Keyboard screen is available in both User mode and Admin mode. Any changes made through
Keyboard preferences screen is saved and continued for the built-in thinuser
34