Dell Wyse 3040 Thin Client User Manual page 30

Parameter
Username
Password
Ask for this password every time
Show Password
4. Click the Identity tab and configure the following settings:
NOTE: Only Administrators are allowed to authenticate these settings by entering the admin password in the root
privilege authentication dialog box after a particular setting is changed or configured.
a. Name— Specifies the default name of the wired connection. If you want to set your preferred name for the connection,
enter the name and then click Apply.
b. MAC Address— Specifies the MAC address of the network connection.
c. Cloned Address— Specifies the IP address that is cloned by the router.
d. Maximum transmission unit (MTU)— Specifies the size (in bytes) of the largest protocol data unit that the protocol layer
can pass onwards.
e. Connect automatically— Select this check box to automatically connect to the network after you plug-in the network wire.
f. Make available to other users— Select this check box if you want to allow other users to configure these settings.
5. Click the IPv4 tab and do the following:
a. Enable the IPv4 button to configure the IPv4 settings.
b. From the Addresses drop-down menu, select the type of IPv4 configuration. The available options are:
• Automatic (DHCP)
• Manual
• Link-Local Only
c. If Automatic (DHCP) option is selected, you must configure the following options.
Table 7. Automatic (DHCP)
Parameter
DNS
Server
Routes
Address
Netmask
Gateway
Metric
30
Description
Enter the Username for the network connection.
Enter the password that you want to set for the
connection.
If this check box is selected, you will be prompted to enter
the password every time when you connect to the network.
Select this check box if you want to allow the user
to view the hidden password.
Description
Enable the Automatic button, if you want the thin client to
automatically fetch the DNS Server.
Specifies the IP address of the DNS Server.
Click the + icon to add a new DNS server to the list.
Enable the Automatic button to turn on the automatic IPv4
routing.
Specifies the Router IP address.
Specifies the Netmask. Netmask is used to divide an IP
address into subnets and specify the network's available
hosts.
Specifies the IP address of the default Gateway.
Specifies the Metric value for the network connection.