Equipment Removal & Installation; G5 Unit; Figure 6-1 G5 Hex Driver - Garmin G5 Maintenance Manual

Electronic flight instrument part 23 aml stc including instructions for continued airworthiness

Hide thumbs Also See for G5:

Table of Contents

EQUIPMENT REMOVAL & INSTALLATION

This section describes how to remove and install the equipment associated with this STC.

When removing and/or installing the G5, always ensure that aircraft power is off.

Unplug any auxiliary power supplies.

Removal

1. Insert a hex drive tool through the access hole in the front cover of the G5 as shown in Figure 6-1

loosen the unit from the mounting ring.

2. Disconnect the pitot and static lines from the G5 unit.

3. Disconnect the electrical connector and GPS coaxial cable connector (if installed) from the G5

unit.

4. Remove the G5 unit.

Reinstallation

1. Inspect the electrical and coaxial connectors and pins for signs of damage. Repair any damage.

2. Reconnect the electrical connector and GPS coaxial connector (if installed) to the G5 unit.

Garmin G5 Electronic Flight Instrument Part 23 AML STC Maintenance Manual

CAUTION:

Page 10 of 18

190-01112-11

Rev. 1

Table of Contents

Show Quick Links

Table of Contents