Electrolux ERSB51I5MLS Instruction Manual page 23

Table of Contents

Advertisement

Available languages

Available languages

43 electrolux usage instructions
Use of Automatic Ice Maker and Ice& Water Dispenser (only
some models)
The water pipes are used in the pressure range of 30-100psi.
Water softeners may damage the ice maker and must not be used.
Please check the ice pieces in the storage box when power off above 1h. If
the ice pieces are thawing and binding together, please empty them, because
the bound ice pieces may cause failure of the ice system.
When the ice pieces in the storage box are binding together, you had better to
melt it with warm water rather than smash and take out them with a sharp
tool, which may damage the refrigeratory.
Supply of cold water (only some models)
1. Choose the ice/water button on the display board, and make sure the water
indicator turns on.
2. When the water switch plate is pressed by the cup, the cold water comes
out.
3. When using the refrigeratory the first time, water does not come out before
the water tank in the refrigerator is filled up. The normal manner to get
water is pushing and holding the switch plate for 2-3 minutes.
4. After the water comes out, please discharge water for about 3 minutes to
purge the air and smell of plastic in the water pipe.
5. When cold water is required, it's better to get some ice before getting water.
6. When getting water, it is normal for noise of valve operation.
Operation of automatic ice maker (only some models)
1.Automatic ice maker operates when the freezer reaches the needed
temperature below °C after a period prescriptive time when the refrigeratory
is energized. Under normal temperature, the time between the refrigeratory's
first energizing and first making of ice is about 6 hours.
2.The ice firstly made after the installation of the refrigeratory shall be thrown
away because of plastic smell and impurities.
3.The time interval of ice making is about 2 hours, and the amount of the ice is
different according to different service conditions.
4.When the ice storage is full, the ice maker will stop automatically, and when
the ice storage is empty, the ice maker will make ice again automatically.
5.The noises for de-icing, motor operation, dropping of ice into the ice storage,
and operation of water supply valve may not happen periodically. They are
not errors.
6.Please use the button on/off on the distributor to turn off the ice-making
function when it is not required. The ice maker is sold under ON state. If
unnecessary, please turn off this function timely after installation of the
refrigeratory. When the ice-making function is turned on without connection
of waterways, there are operational noises of water supply valve.
7.When ice piece is smaller than usual in a certain period of time, please verify
the replacement frequency of the filter. When the filter reaches its operation
time, the water supply pressure is lower and the made ice piece is smaller.
8.When cleaning the ice storage box, turn off the ice-making function on the
distributor before detaching the ice storage box.
9.Do not whirl the Auger during reinstallation of the removed ice storage box.
After being whirled, the Auger cannot be assembled and installed normally. It
may be damaged when taking out the ice. Whirl the Auger left and right after
it has been whirled to ensure normal installation.
Supply of ice (only some models)
1. Choose the ice/ water button on the display
board, select entire or crushed ice pieces
and make sure the relevant indicator turns
on.
2. Use the container to push and hold the
switch plate to get ice.
3. According to the water supply condition,
some mixed small ice pieces may come out
when getting the entire ice pieces.
4. When crushed ice pieces are required,
please press the container most close to
the ice discharging orifice to prevent the
crushed ice from dropping out.
5. When getting ice, the noises of motor,
crushing ice and so on are normal.
6. To protect the motor, the refrigeratory will
stop when the switch plate is pushed for 1
minute or more. Then, releasing the switch
plate and waiting a moment, you can get
ice normally again. When large amount of
entire ice pieces are required, please open
the door of freezer, take the ice storage box
out and use the ice in it.
usage instructions electrolux 44

Advertisement

Chapters

Table of Contents
loading

Table of Contents