Speed Control Specification; Lubricating The Drive Shaft - H-King Marine Scott Free Offshore Instruction Manual

Deep v racing boat
Table of Contents

Advertisement

The H-King Marine brushless motor boat is assembled with 60A water cooled brushless ESC,
please see below the specification:
Protections: Thermal protection activated at 120°C. LVP (low voltage protection) engaged when
LiPo battery (per cell) drops down to 3.2 Voltage.
Operating Cells: 2S-4S LiPo
Current Rating: 60A
Peak Current: 70A within 10 seconds
BEC Output: 2A/5V
Calibration: 1. Set the trigger to maximum throttle then turn on the transmitter.
2. Connect motor and receiver to the ESC.
3. Plug battery to power on ESC.
4. After 4 high pitched tones, set the trigger to minimum throttle.
5. After 3 repeat monotones, cut off the power of ESC.
Lubricating the flexshaft is vital to the life of the drivetrain. The lubricant also acts as a water seal, keeping water
from entering the hull through the stuffing box.
Lubricate the flexshaft, propeller shaft and all moving parts after every 2-3 hours of operation.
1. Use the 2mm Allen key to loose the two grub
screws of the coupler which connects the
flexshaft, then slide the flexshaft w/ prop shaft
out of the stuffing tube.
2. Lubricate the flexshaft w/ prop shaft with the
water proof marine grease, reinstall the flexshaft
w/ prop shaft in reverse order, be sure to retighten
the two grub screws of coupler.
NOTE: Running the model boat in salt water could cause some parts to corrode. If you run the boat
in salt water, rinse it thoroughly in fresh water after each use and lubricate the drive system.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
CAUTION: Changes or modifi cations to this product not expressly approved by the party responsible
for compliance may void the user's authority to operate the equipment.

Speed Control Specification

Lubricating The Drive Shaft

FCC REQUIREMENT
8

Advertisement

Table of Contents
loading

Table of Contents