Items Required For Completion & Battery Pack Recommendations You will need to purchase the following items to operate your H-King Marine brushless motor boat. We highly need to purchase the following items to operate your H-King Marine brushless motor boat.
Contents of Set ● Water cool 2815 out-runner brushless motor (included) (Pre-installed) ● 60A Water cooling Brushless ESC w/BEC (Pre-installed) Cable Strap ● Powerful Steering 37g Servo (Pre-installed) ● 2.4GHz 2CH Pistol Transmitter (RTR Version only) HXT4mm Plugs (2pcs) ● Display Boat Stand Boat Stand 2 pcs of Allen Key Water proof...
Page 4
installing the rudder and propeller Concerning the package safety, the rudder and propeller are not pre-installed. They are packed well in the kits bag. Follow the belowing steps to install them by yourself easily. 1. Loosen the screw on the propeller shaft by 7mm Spanner, put the propeller in then retighten the screw.
Receiver connection diagram Caution: Before racing boat, Please use balloon supplied in tool bag to wrap receiver for water proofing. Installing the Battery 1. Rotate the plastic lock on hatch 90 degrees either to left or right. 2. Lift up and remove the hatch. 3.
TRANSMITTER/RECEIVER BINDING The binding process effectively ties the transmitter and receiver together. Under normal circumstances, both items are supplied like this from the factory. If, however, you find that your transmitter and receiver are not bound (receiver’s red LED is flashing), you should do the following: 1) Insert BIND plug into “BIND/VCC”...
Transmitter introduction Bind ST.REV TH.REV Steering reverse Throttle reverse BIND R LED G LED R.LED G.LED Steering TRIM Steering DR Throttle TRIM ST.TRIM TH.TRIM ST.DR Power POWER EPA Adjustment Function Use this when performing left and right steering angle ST.REV TH.REV BIND adjustments.
Speed Control Specification The H-King Marine brushless motor boat is assembled with 60A water cooled brushless ESC, please see below the specification: Protections: Thermal protection activated at 120°C. LVP (low voltage protection) engaged when LiPo battery (per cell) drops down to 3.2 Voltage.