Table of Contents
Advertisement
installing the rudder and propeller
Concerning the package safety, the rudder and propeller are not
pre-installed. They are packed well in the kits bag. Follow the
belowing steps to install them by yourself easily.
1. Loosen the screw on the propeller shaft by 7mm Spanner, put
the propeller in then retighten the screw.
2. Insert the rudder support into the support which is already
installed on the rear of hull. Thread the two pcs of M3 screw in,
Apply two pcs of M3 nut on the screws, retighten the screws
and nuts by 2.5mm Allen Key and 5.5mm Spanner.
3. Thread the silicone tube in the brass water inlet.
4. Loosen the adjuster on the servo horn so as to push rudder rod
to thread in the adjuster located in the rudder horn. Make sure
the rudder centered and then Retighten the two adjuster with
2.5mm Allen Key.
Rudder Assembly
NOTE: Please install rudder and support on the right
support which is pre-installed on the rear of hull in
factory. Installing rudder and support on the right
side is effective for good performance and
stability.
Installing transmitter batteries (RTR version only)
NOTE: The transmitter is not water resistant and should
never come in contact with water.
1. Install four fresh "AA" batteries. Follow the diagram
located in the bottom of the battery tray for proper battery
orientation.
2. Turn the transmitter "ON".
2.5mm
1
4
Advertisement
Table of Contents
