Internal Microphone Failure
If internal Microphone fail, perform the following:
Figure 4-7. Microphone Failure
1. Check that the microphone is enabled. Navigate to
and Sound Sound
2. Right click on the Recording tab and select Show Disabled Devices (clear by
default). The microphone appears on the Recording tab.
3. Right click on the microphone and select
4. Select the microphone then click
5. Increase the volume to the maximum setting and click
6. Test the microphone hardware:
Select the microphone and click
Set up microphone
Select
Select the microphone type from the list and click
Follow the on-screen prompts to complete the test.
7. If the Issue is still not resolved, refer to
Troubleshooting
Start
Check M/B Mic.
cable
Check MIC wire
of LCD module
Swap M/B
and select the Recording tab.
Properties
Configure
.
0
OK
Re-assemble the
NG
MIC cable to M/B
OK
Swap MIC wire of
NG
Start Control Panel Hardware
Enable
.
Levels
. Select the
OK
.
.
Next
.
Online Support Information
LCD module
tab.
.
4-13