Mitsubishi 3000GT Workshop Manual Supplement page 38

35-22 SERVICE BRAKES
-
Hydraulic UniUG-Sensor
INSTALLATION SERVICE POINT
1.
BRAKE PIPE INSTALLATION
Connect
the tube to the hydraulic unit as shown in
the
illustration.
(1)
From hydraulic unit to front brake (L.H.)
(2)
From hydraulic unit to rear brake (R.H.)
(3)
From hydraulic unit to rear brake (L.H.)
(4)
From hydraulic unit to front brake (R.H.)
(5)
From master cylinder
to
hydraulic unit (front L.H. line
and rear R.H. line)
(6)
From master cylinder to hydraulic unit (front R.H. line
and rear L.H. line)
G-SENSOR
INSPECTION
1.
Disconnect
the G-sensor connector and connect the
special tool between the terminals of the disconnected
connector.
2.
Turn the ignition switch
to ON and take
a
reading of the
following output voltage.
Between terminals No.2 and No.3.
Standard value:
2.4
-
2.6 V
With the special tool still connected, secure the G-sensor
so that
the läbel surface is facing straight down, and then
take a reading of the following output voltage.
Between terminals No.2 and No.3.
Standard value:
3.4
-
3.6 V
lf the voltage is outside the standard value, after checking
to be sure that there is no abnormality in
the power supply
and earth wires, replace the G-sensor.
4.