Control Panel - Pro-Elec HG00923 Instruction Manual

CONTROL PANEL

Indication Lights
Power: turns green when the unit is plugged in, regardless of whether the unit is
operating or not.
Tank full: turns red when the tank is full. If the light is on, empty the water out of the
drainage tank and make sure that the tank is repositioned properly.
Timer: turns green when the timer to turn the unit on or off automatically is
programmed.
Adjustable humidity setting: turns green when the humidity level is being adjusted.
Humidity level and Timer display: this 2 digit display indicates 5 functions:
1. When the unit is plugged in, it will indicate the room humidity level.
2. When the humidity level is being set, it will indicate the humidity level selected.
3. When the humidity in the room is less than 35%, it will show LO
4. When the humidity in the room is higher than 95%, it will show HI
5. When the timer to turn the unit on or off is being set, it will show the number of
hours selected.
Push Button Functions
Power: press the button once to start operation, the default humidity level is 60%.
Press it again to stop operation.
Timer: 24 hour timer setting. Press the button to program the number of hours delay
to when the unit turns on and off. It can be set between 1 and 24. To cancel the timer
programming, press the button to adjust the time to 00
Adjustable humidity: press to set the desired humidity level in the room, which can
be set in the order: 60%, 65%, 70%, 75%, 80%, 40%, 50%, 55%, 60%. When the
relative humidity in the room is lower than the selected humidity, the operation of the
unit will stop automatically.
Fan speed: press to set the desired fan speed. There are two settings high or low
speed.
6