Troubleshooting - Pro-Elec HG00923 Instruction Manual


Refit the air filter
Note: Do not run the dehumidifier without the air filter.
Storing the dehumidifier
If the dehumidifier is not going to be used for a long time, please follow the steps below:
1. Unplug the dehumidifier from the mains.
2. Empty any water left in the drainage tank and dry thoroughly
3. Fold up the power supply cord and put it in the drainage tank
4. Clean the air filter
5. Store in a dry place

TROUBLESHOOTING

If one of the conditions listed below occurs, please check the following:
Problem
The unit doesn't operate
The dehumidifying
function doesn't work
No air is discharged
Operation is noisy
If a problem persists, turn the dehumidifier off and unplug from the mains. Consult either your
retailer or a qualified person for additional assistance.
Possible Cause
Has the power cord been
disconnected?
Is the tank full indication
lamp blinking? (The tank is
full or in the wrong position.)
Is the temperature of the
room above 35℃ or below
5℃?
Is the air filter clogged?
Is the air intake or
discharge duct obstructed?
Is the air filter clogged?
Is the unit tilted or
unsteady?
Is the air filter clogged?
10
Solution
Plug the power cord into the
outlet.
Empty the water in the
drainage tank and then
reposition the tank
correctly.
The protection device is
activated and the unit
cannot be started.
Clean the air filter as
instructed under
"Maintenance".
Remove the obstruction
from the air intake or
discharge duct.
Clean the air filter as
instructed under
"Maintenance".
Move the unit on to a stable,
level location.
Clean the air filter as
instructed under
"Maintenance".