Table of Contents
Advertisement
Connecting the power cord
1
Plug the female end of the supplied power cord into the Mains jack
on the rear of the player.
2
Connect the other end of the cord to an AC outlet.
Note: When the player is in the "STANDBY" mode, it is still consuming some
power. If you wish to disconnect your player completely from the power, unplug
the power cord from the AC outlet.
Caution: Only qualified service personnel should remove the
cover or attempt to service this device.
Remote control battery installation
Loading the batteries
1
Open the battery compartment cover.
2
Insert two 'AA' batteries as indicated inside the battery
compartment.
3
Close the cover.
Caution: Do not mix old and new batteries. Never mix
different types of batteries (standard, alkaline, etc.)
NTSC/PAL Settings
You can switch the NTSC/PAL setting of the DVD player to match the
video signal of your TV.This setting only affects the television's on-screen
display that shows the stop and setup modes.You may select either
NTSC or PAL.To change the DVD player setting to PAL or NTSC,
follow the steps below.
1
Unplug the DVD player from the mains.
2
Press and hold 9 and T on the front of the DVD player.While
holding 9 and T, plug in the mains.
3
After PAL or NTSC appears on the display panel of the DVD player,
release 9 and T at the same time.The PAL or NTSC that appears on
the display panel indicates the current setting.
4
To change the setting, press T within three seconds.The new setting
(PAL or NTSC) will appear on the display panel.
PREPARATION 19
Advertisement
Table of Contents
