Specifications, Glossary 51 - Philips DVD795SA Owner's Manual

Specifications
CABINET
Dimensions (w x h x d):
Weight:
POWER SUPPLY
Power supply
Power consumption
Standby power consumption
TV STANDARD
Number of lines
Playback
VIDEO PERFORMANCE
CVBS VIDEO OUT
S-VIDEO OUT
Y Pr/Cr Pb/Cb
AUDIO PERFORMANCE (TYPICAL)
DA Converter
Signal to Noise (1kHz)
Dynamic range (1kHz)
Crosstalk (1kHz)
Total Harmonic Distortion (1kHz) 91 dB
MPEG MP3
DVD
Video CD/Audio CD
Super Video CD
AUDIO FORMAT
Direct Stream Digital/Multichannel/Stereo/MPEG/Compressed Digital
Dolby Digital
Glossary
Analog: Analog sound is available when you use the red and white audio jacks on your equipment. These jacks send audio through
two channels, the left and right.
AUDIO OUT Jacks: Jacks on the Player that send audio to another system (TV, Stereo, Receiver, etc.).
Bit Rate: The amount of data used to hold music; measured in kilobits per seconds, or kbps. Or, the speed at which you record.
Generally, the higher the bit rate, or the higher the recording speed, the better the sound quality. Higher bit rates use more Disc
space.
Coaxial jack: Sends digital audio to a Stereo, allowing you to adjust the volume at the Stereo. The Stereo must have a coaxial in
jack. This connection provides the 5.1 channel surround sound.
Component Video Out Jacks: Jacks on the back of the Player that send high-quality video to a TV that has Component Video
In jacks.
Digital: Sound that has been converted into numerical values. Digital sound is available when you use the Coaxial or Optical
Digital Audio Out jacks. These jacks send audio through multiple channels, instead of just two channels as analog does.
Direct Stream Digital (DSD): Technology used to record SACDs. DSD uses a 1-bit system with a digital sampling frequency
64 times higher than a regular Audio CD, creating a frequency response of over 50 kHz and a 120 dB dynamic range.
Dolby Digital: A surround sound system that provides 5.1 channel sound.
DTS: Digital Theater Systems. This is a surround sound system, but it is different from Dolby Digital. The formats were devel-
oped by different companies.
Letterbox: A TV aspect ratio setting (4:3). Displays the video in full-width, with black bars at the top and bottom of the TV
screen. This format is similar to seeing a movie in a theater.
OPTICAL Jack: Converts electrical signals into optical signals before sending the audio to the Stereo. Optical audio is not prone
to external electrical influences and has less noise. Keep the protective cap on the jack when it is not in use; this keeps dust out of
the jack.
Pan & Scan: A TV aspect ratio setting (4:3). Displays the video with full-height picture, with one or both sides of the picture
trimmed. Some movie companies refer to this as "reformatting the picture to fit your TV screen."
S-Video: Produces a clearer picture by sending separate signals for the luminance and the color. If you connect the supplied S-
Video cable, you will not need to use the supplied yellow video cable. You can use S-Video only if your TV has an S-Video In jack.
VIDEO OUT Jack: Jack on the back of the Player that sends video to a TV.
Widescreen: A TV aspect ratio setting (16:9). Displays the video appropriately when you connect the Player to a widescreen TV.
17.13 x 4.53 x 16.38 inches
(435 x 115 x 416 mm)
Approximately 13.01 lbs (5.9 kg)
120V, 60 Hz
Approximately 30W
<1W
PAL/50Hz NTSC/60Hz
625 525
Multistandard (PAL/NTSC)
1 Vpp into 75
Y: 1 Vpp into 75 ; C: 0.3 Vpp into 75
Y: 1 Vpp into 75 ;
Pr/Cr and Pb/Cb: 0.7 Vpp into 75
24 bit
100 dB
98 dB
95 dB
MPEG Audio L3
fs 96 kHz 4 Hz -44 kHz
fs 48 kHz 4 Hz -22 kHz
fs 44.1 kHz 4 Hz -20 kHz
fs 48 kHz 4 Hz -22 kHz
fs 44.1 kHz 4 Hz -20 kHz
16, 20, 24 bits

Specifications, Glossary 51

DTS/PCM
MP3
(ISO 9660)
SACD AUDIO PERFORMANCE
DA Converter
Signal to Noise (1kHz)
Dynamic range (1kHz)
Crosstalk (1kHz)
Total Harmonic Distortion (1kHz) 91 dB
SACD
Maximum Output Voltage (0dB)
Channel unbalance
Cut-off frequency
REAR CONNECTIONS
Y Pr/Cr Pb/Cb
(480 lines Interlace/Progressive) Cinch (green/blue/red)
S-Video Out
CVBS Video Out
Audio Out
Digital Audio Out
Front and Surround
Center
Subwoofer (SUB WF)
LASER
Type
Wavelength
Output power
Beam divergence
fs 44.1, 48, 96 kHz
96, 112, 128, 256 kbps and
variable bit rate fs 32, 44.1, 48kHz
Direct Stream Digital
105 dB
100 dB
98dB
fs 2.8224 MHz DC 100kHz
2V rms
<0.5 dB
50 kHz (Front)
40 kHz (Surround/Center/Subwoofer)
Mini DIN 4-pins
Cinch (yellow) (two)
Cinch (white/red, left/right)
one coaxial, one optical
IEC958 for Audio CD and LPCM
IEC1937 for MPEG1/2
/Dolby Digital/DTS
Cinch (white/red, left/right)
Cinch (blue)
Cinch (black)
Semiconductor laser GaAIAs
650nm (DVD)
780nm (Video CD/Audio CD)
7mW (DVD)
10mW (Video CD/Audio CD)
60 degree