Cutting Table; Cooling System; Technical Data; Unpacking & Setting Up - Beast RS34 Operating Manual

Water pump

Cutting table

spindle. The saw flange is to be mounted
on the saw spindle with a hexagon nut to
clamp the saw blade.
Cutting table
The cutting table is constructed of
removable aluminum components for
easy maintenance, and a stainless steel
adjustable side stop.

Cooling system

The electrical water pump is switched on
simultaneously with the saw motor and
supplies cooling water to both sides of the
saw blade. A drain hole, with a plug, is
located in the water container. Mud flaps
prevent most of the water mist and make

Technical Data

Type
Capacity
Blade diameter/hole
Cutting height
Saw spindle speed
Cutting length
Length
Width
Height (without legs)
Weight
Noise level
Noise level (sawing)
RS34 - RS48 - RS59
®
Blade guard
Saw spindle
Detachable legs
RS34
2 HP
10"
max. 2"
3.360 RPM
34"
48"
19"
24"
115 lbs
81 dB (A)
92 dB (A)
BEAST BRIDGE SAWS OPERATING MANUAL
sure most water flows back in the water
container.
UNPACKING & SETTING UP

Unpacking and Assembly

• Unpack the tile saw and inspect for
any damaged parts.
• Install the legs in the sockets at the
under side of the water container and
fasten with the knobs. Markings show
the right position.
• Level the tile saw by adjusting the legs
in the sockets and make sure its stable.
• Release the transportation lock.
RS48
2 HP
10"
max. 2"
3.360 RPM
48"
61"
19"
24"
137 lbs
81 dB (A)
92 dB (A)
RS59
2 HP
10"
max. 2"
3.360 RPM
59"
73"
19"
24"
154 lbs
81 dB (A)
92 dB (A)
9