Operating Instructions; Single Step Cutting; Multiple Step Cutting; 45˚ Miter Cutting - Beast RS34 Operating Manual

OPERATING INSTRUCTIONS

Single Step Cutting

DO NOT FORCE THE TOOL! It will do
the job better and safer at the rate for
which it was designed.
Use original Beast ®
only.
• Loosen the Adjustable Cutting Guide
retaining knob.
• Position the Adjustable Cutting Guide
to desired cutting length.
• Tighten the retaining knob.
• Place the tile against the Ruler/Stop
and Cutting Guide.
• Turn the motor ON.
• Verify proper coolant flow on both
sides of the blade.
• Perform the cut.
• Turn the motor OFF when work is
complete.

Multiple Step Cutting

During this sawing process the saw is
positioned at the desired height and
moved back and forth through the material
to be cut until after a number of steps it is
completely cut through.
• Place the material to be cut on the
sawing table and position against the
fixed stop and eventually the adjust-
able stop.
RS34 - RS48 - RS59
®
wet cutting blades
• Position the cutting head at the desired
height
• Hold the material with one hand while
making sure your hand is free from the
cutting blade.
• Perform the cut. This process must be
repeated until the material has been
totally cut through.
• Turn the motor OFF when work is
complete.
45˚ Miter Cutting
The Beast ® Tile Saw is designed to
perform 45˚ Miter Cuts without additional
tools.
• Loosen the 2 handles on either side of
the machine.
• Tilt the cutting head into the 45˚
position.
• Fasten both handles.
• Place the tile on the cutting table in the
desired position.
• Hold the tile down with one hand.
(Keep hand away as far as possible
from the cutting blade.)
• Turn the motor ON.
• Verify proper coolant flow on both
sides of the blade.
• Perform the cut.
• Turn the motor OFF when work is
complete.
BEAST BRIDGE SAWS OPERATING MANUAL
11