Beast RS34 Operating Manual page 7

risk of electric shock. The equipment-
grounding conductor is the insulated
conductor that has an outer surface
that is green with or without yellow
stripes. If repair or replacement of the
electric cord or plug is necessary, do
not connect the equipmentgrounding
conductor to a live terminal.
• Check with a qualified electrician or
service personnel if the grounding
instructions are not completely under-
stood, or if in doubts to whether the
tool is properly grounded.
• Use only 3-wire extension cords that
have 3-prong grounding plugs and
3-pole receptacles that accept the
tool's plug.
• Repair or replace a damaged or worn
cord immediately.
WARNING: This tool is intended
for use on a circuit that has a 3
pole outlet.
WARNING: To reduce the risk of
electrocutation, keep all connec-
tions dry and off the ground.
A Ground Fault Circuit Interrupter (GFCI)
should be provided on the circuit(s)
or outlet(s)to be used for the Saw.
Receptacles are available having built-in
GFCI protections and may be used for this
measure of safety. A GFCI is not supplied
with the machine.
When using an extension cord, the GFCI
should be installed closest to the power
source, followed by the extension cord
and lastly, the saw.
CAUTION: Shock Hazard. For
replacement, use only an identi-
cal Beast water pump, item #
6.513.298
RS34 - RS48 - RS59
®
This method of positioning the cord
prevents the travel of water along the
power cord and the possibility of the water
coming in contact with the receptacle. If
the plug or electrical outlet gets wet, DO
NOT unplug the cord. Disconnect the fuse
or circuit breaker that supplies power to
the machine. Then unplug and examine
the machine for the presence of water in
the outlet.
BEAST BRIDGE SAWS OPERATING MANUAL
WARNING: To avoid the possi-
bility of the machines plug or
electrical outlet getting wet, posi-
tion the saw to one side of a wall
mounted outlet. This will prevent
water from dripping onto the
outlet or plug. A "drip loop"
should be arranged by the user
to properly position the power
cord relative to the power
source. The "drip loop" is that
part of the cord below the level
of the outlet, or the connector, if
an extension cord is used.
WARNING: It is important to use
extension cords that are only
intended for outdoor use. These
extension cords are identified by
a marking "Acceptable for use
with outdoor appliances; store
indoors while not in use".
WARNING: It is important to
only use extension cords having
an electrical rating not less than
the rating of the product.
WARNING: It is important not to
use damaged extension cords.
Examine the extension cords
before using it and replace it if it
is damaged.
7