Table of Contents
Advertisement
TITLE
CHAPTER
TRACK
TOTAL
TRACK
TIME
V
CD
A
-B
REPEAT
SHUFFLE
CHAPTER
TITLE
TRACK
OPEN/ CLOSE
Cleaning discs
Some problems occur because the disc inside the player
is dirty.To avoid these problems clean your discs regularly, in the
following way:
When a disc becomes dirty, clean it with a cleaning cloth.Wipe the disc
from the centre out.
Caution: Do not use solvents such as benzine, thinner,
commercially available cleaners, or anti-static spray intended
for analog discs.
Diagnostic program
If the player is still faulty you can start the Diagnostic
Program in the player.
How does the Diagnostic Program work: you can operate the Diagnosis
Program by following the instructions step by step.
Instructions
1
Unplug the power cord of the player.
2
Press the OPEN/CLOSE and ; button simultaneously and keep them
PLAY
pressed while you plug the player.
PAUSE
STOP
This counter indicates the termination of the test when zero is reached.
from
failure in your player and your player should be repaired.
3
Consult your dealer or the Philips Customer Care Centre for the
nearest Service Repair Shop in your country. The phone number is given
in your warranty booklet.
4
If the message
in your player, in this case the failure can be caused by incorrect
interpretation of the operating instructions or a wrong disc is used or
your player is not correctly connected.In this case you should consult
your dealer or the Philips Customer Care Centre for further assistance
in solving the problem.
5
If the problem remains, then go to point 3 of this instruction to find the
nearest repair shop.
6
Unplug the power cord of the player.
7
Replug the power cord in the AC outlet.
On the display the message
After a few minutes the message on the local display changes over
to
or to
BUSY
ERROR
PASS
If the message
appears on the display, there is apparently a
ERROR
appears on the display, there is apparently no failure
PASS
appears together with a counter.
BUSY
.
BEFORE REQUESTING SERVICE 33
Advertisement
Table of Contents
