Before You Begin - Wings Maker SZD-45 OGAR Instruction Manual

BEFORE YOU BEGIN

PARTS LIST
ASSEMBLY
SAFETY PRECAUTIONS
BEFORE YOU BEGIN
1 Read through the manual before you begin, so you will have an overall idea of what to do.
2
Check all parts. If you find any defective or missing parts contact your local dealer. Please
DRY FIT and check for defects for all parts that will require CA or Epoxy for final assembly.
Any parts you find to be defective after the gluing process may be difficult to remove for
warranty replacement. The manufacturer will replace any defective parts, but will not extend
to the parts that are good before gluing to defective parts during assembly. Warranty will
not cover any parts modified by customer.
3
Symbols used throughout this instruction manual comprise of the following :-
Apply epoxy glue.
Apply thread locker
Assemble left and right
sides the same way.
Peel off shaded portion
covering film.
Drill holes with the specified
diameter (here: 3mm).
3mm
Pay close attention here!
GM048PO26141105
szd-45 ogar
INDEX
Apply instant glue
(C.A.glue, super glue.)
Must be purchased separately !
Ensure smooth non-binding
movement while assembling.
Cut off shaded portion.
Pierce the shaded portion
covering film.
Warning!
P.1
P.1
P.2
P.3-P.9
P.9
Do not overlook this symbol !