Blade Maintenance; Operation Instructions - Worx WG800 Manual

OPERATION INSTRUCTIONS

1. STARTING AND STOPPING
Starting:
To switch ON your Shear firstly press the Lock
off button(2)then depress the On/Off switch
(4)
Stopping:
To switch Off simply release the On/Off
switch(4)
NOTE: Follow the above steps when operating
by the extension handle.
WARNING: The switch (2 and 4)
must be pressed simultaneously
when staring the machine. Do not
operation the machine when charging!
2. WORKING INSTRUCTIONS
NOTE: Hold the machine away from yourself.
Stand in a secure and stable position.
a. Shrub shear
Cutting hedges
Before cutting check the hedge for foreign
objects e. g. wire fences.
Cut stems up to 8 mm in thickness. When
cutting, move steadily along the line of cut,
so that stems are fed directly into the cutter
blades. The double edge of the cutting blade
enables cutting to either direction, or with a
side to side motion.
After use replace the blade transport guard.
Recommended cutting/trimming times:
– Cut hedges with deciduous leaves in June
and October.
– Cut evergreen hedges in April and August.
– Cut conifer and other fast growing shrubs
approx. every six weeks from May onwards.
b. Shrub shear/ edging shear with
extension handle (WG800.2)
Edging
Guide the machine along the edge of the
lawn. Do not allow the blade to contact paved
surfaces, stones or garden walls, since this will
wear the blade rapidly.
For larger lawn it is advisable to use the
extension handle (only for WG800.2).
MAINTENANCE
NOTE: To ensure long and reliable service,
3.6V Cordless Shrub Shear and Edging Shear EN
carry out the following maintenance regularly.
Check for obvious defects such as loose,
dislodged or damaged blade, loose fixings and
worn or damaged components.
Check that covers and guards are undamaged
and correctly fitted. Carry out necessary
maintenance or repairs before using.

BLADE MAINTENANCE

Always clean the cutting blades after operation
and periodically lubricating the cutting blade.
Visually check the condition of the cutting
edges of the cutting blade.
Ensure that the blade is covered with the blade
guard supplied when not in use.
WARNING: Wearing of gloves is
recommendedwhen changing the
blades.
CLEANING/STORAGE
Clean the exterior of the machine thoroughly
using a soft brush and cloth. Do not use
water, solvents or polishes. Remove all debris,
especially from the ventilation slots.
Store the machine in a secure dry place out of
reach of children. Do not place other objects
on top of the machine.
TRANSPORT
The battery has effective protection against
internal overpressure and short circuiting
as well as measures for prevention against
forced rupture and dangerous reverse current.
The lithium equivalent contents contained
in the battery is below the spilling limit
values. Therefore, the battery is not subject
to the national and international regulations
governing dangerous goods, neither as
individual components nor when inserted into
a machine. However, the Dangerous Goods
Regulations can be relevant when transporting
several batteries. In this case, it can be
necessary to observe special conditions (e. g.
for packaging).
13