Table of Contents
Advertisement
•
Available settings are 1-3 with a factory
default of 3. Refer to the THERMOSTAT
Mode section for additional details on
flame modulation in THERMOSTAT
mode.
•
While in MANUAL ON, THERMOSTAT
ON, or PROGRAM ON modes, touch
the FLAME Zone to enter Flame-A Ad-
justment, then press the UP or DOWN
buttons to raise and lower the fl ame;
press the MODE/SET Button or wait for
15 seconds to accept the new setting.
•
LCD Display: When setting the Flame-A
height, the Flame-A icon, and Flame-A
setting number will fl ash in the FLAME
Zone.
Child-Lock Operation
•
Child-Lock operation prevents any user
input to the transmitter. No mode of op-
eration or feature may be adjusted when
Child-Lock is activated. All automatic
functions (thermostat, program, etc.) will
continue normally.
•
To activate or deactivate the Child-Lock
feature, press and hold the MODE/SET
and DOWN Buttons simultaneously for
5 seconds.
•
LCD Displays:
• When activated, the LOCK icon will ap-
pear in the MODE Zone.
• If any touch-zone or button is pressed
when activated, the LCD backlight will
illuminate and the LOCK icon will fl ash
for 5 seconds in the MODE Zone.
Room Temperature Limit
•
The Room Temperature Limit Shut-
down feature will operate in MANUAL
ON, THERMOSTAT ON mode, and
PROGRAM ON modes. If the room tem-
perature reaches 95 deg. F or greater,
the transmitter will automatically change
to MANUAL OFF mode and send a
MANUAL OFF command to the control
module. If the user turns the control
back ON and the room temperature is
still 95F or greater, the transmitter will
switch to back manual OFF and send
another OFF command the next time
the transmitter reads & updates the room
temperature (2-minute update interval).
126818-01C
OPERATION
Continued
PAIRING
The remote and receiver are paired at the
factory but in case they do not communicate
after proving the batteries are fresh, repair-
ing may be necessary. Follow the steps
below to repair the remote to the receiver.
It is helpful to have a fl ashlight so you can
see the connections as described below.
Before proceeding, locate the S1 but-
ton on the receiver shown in the figure
below. You will need to access this button
during the re-pairing procedure and only
have 20 seconds to press and release it.
To enter pairing mode press and hold the
MODE/SET Button for 10-seconds.
•
Transmitter will transmit a pairing sig-
nal for 20-seconds, then automatically
exit pairing mode and return to normal
operation.
•
LCD Displays – When pairing mode is
activated:
1. MODE Zone: Blank
2. ROOM TEMP Zone: The letters "On"
3. SET TEMP Zone: The letter "P" is
4. TIME/PROG Zone: Blank
5. FLAME Zone: Blank
Receiver Operation NOTE: Once transmitter
is in pairing mode, press the yellow or black
pairing button on the receiver.
TOUCH PAD OPERATION
This touch control has only 3 buttons for con-
trolling manually the fl ame of the appliance
(see Figure 53).
Connect Battery Plug Here
SuperiorFireplaces.US.com
will fl ash.
displayed
S1 Button
Control Module
29
Advertisement
Table of Contents
