Using The Pull Out Crevice Tool; Fitting The Handle To The Main Chassis; Fitting The Dustbuster To The Chassis; Removing And Clearing The Beater Bars - Black & Decker SVJ520BFS Dustbuster User Manual

Using the pull out crevice tool (Fig. B,C)
Extend the crevice tool (3) as shown in figure C, until
u
it clicks in place. The push in brush (4) can be fitted if
required for dusting and upholstery cleaning.
To retract the crevice tool (3) press the crevice tool release
u
button (3a) allowing it to return to its normal position
(Fig. B).

Fitting the handle to the main chassis

(Fig. D, E)
Slide the handle (6) into the main chassis (8) as shown in
u
figure D.
Secure with retaining screw (17) as shown in figure E.
u
Fitting the Dustbuster
(Fig. F, G, H)
Slide the Dustbuster , nozzle first, into the chassis (8)
®
u
until an audible 'click' is heard as shown in figure F.
To release the Dustbuster
u
chassis release button (8a) and lift clear.
The appliance can now be operated via the on/off button
u
(5) on the handle (6) along with the 'BOOST' mode as
shown in figure H. This also allows you to utilise the beater
bars via the 'brush on' control (5A).

Removing and clearing the beater bars

(Fig. I, J)
To remove the beater bar unit (9) from the floor head (10)
u
Depress the release button (11) as shown in figure I.
The beater bar (12) can now be removed. The end pieces
u
are also removable allowing you to clear the brushes from
any hair or other debris that may have accumulated (Fig.
J).
Charging (Fig. K, L)
Place the appliance into the charging base (7) as shown in
u
figure K .
Plug the charging port (7) into an electrical outlet.
u
Switch the electrical outlet on. The LED charging indicator
u
(B) will Illuminate (Fig. L).
to the Chassis
®
from the chassis press the
®
(Original instructions)
Multi LED Display
A
B
C
A. Filter sensor
Whenever a filter is Blocked and needs cleaning, the red
filter LED (A) in the handle will illuminate.
Clean fine dust from filter (See section on 'cleaning filters'
in this manual).
B. LED Charging display
Battery icon (B) will illuminate when appliance requires
charging. Led display indicates state of charge (See LED
pattern chart in this manual).
C. BOOST mode
Illuminates when the appliance is in BOOST mode
allowing you to operate at higher power.
LED Patterns
ENGLISH
Charging
Battery Fault
Charger Fault
Battery Hot
9