Setup - Philips DCR 2020 User Manual

Setup

Setup is used to:
• Install channels
• Test signal level and quality
• modify the general settings of your receiver
• check for software updates
• restore the receiver factory settings.
Access to this menu can be protected by Pin Code.
Channels installation
- Select appropriate values for the following:
• Network ID: applicable network ID as indicated
by your operator. See operator booklet for the
right decimal value to be entered for your region.
• Frequency: broadcast frequency predefined or
entered manually as indicated by your operator
(see operator booklet).
• Symbol Rate: predefined or entered manually as
indicated by your operator.
• Modulation: modulation type predefined or
entered manually as indicated by your operator.
Symbol rate and modulation values should not be
modified unless requested by your operator.
- Press OK to start scanning for channels.
Signal Test
Signal Test is used to view the signal level and quality for
the frequency defined at installation.
TV Configuration
Select appropriate values for the following:
• TV Format: 4:3 or 16:9
• TV aspect ratio: full format, 16:9 Letter Box, 4:3
Center
• TV output signal: CVBS, RGB, or S Video
• TV audio signal: Stereo, Mono, or Dolby Digital.
• VCR Video Output: CVBS or S Video
• VCR Recording control: NO, PREPARE
RECORD, or RECORD LINK. See chapter More
about recording (VCR or DVD control).
• Video mode: PAL or SECAM
- Press OK to store the settings.
EN
61