Starting Your Appliance; Using Your Electronic Control; Sleep Mode; Turning Your Appliance "On" Or "Off - AGA marvel MP24FAS4 SERIES Installation, Operation And Maintenance Instructions

Starting your appli-
ance:
Power Failure
ALARM RESET
Plug the appliance power
cord into a 115 volt wall outlet. Your ap-
pliance is shipped from the factory in the "On" po-
sition and will begin start-up of cooling as soon as
power is supplied. If the appliance does not start,
confirm that the wall outlet has power, and that the
control is in the "On" position, (See "Turning your
appliance On and Off" below).
The control display is covered with a clear plastic
film. This film may be removed by carefully lifting
the film at a corner.
On initial power up, the control display will indicate
a "Power Failure" alarm. This is a normal condition
as the appliance was powered-up at the factory for
quality inspection and then removed from power. A
momentary press of the "On/Off" keypad will reset
this alarm condition. (See Alarms section on page
10).
Temp Temp
Minus Plus
keypad keypad
On/Off
keypad

Using your electronic control:

Sleep mode:

If no keypads are pressed for 60 seconds, the
display will enter sleep mode to conserve power.
The control panel will go dark with the exception of
the system status "OK" indicator which will remain
enabled. Alarm conditions will wake the display,
(see alarms on page 10).
To make the following changes to the con-
trol settings (turning the appliance ON/OFF,
adjusting the temperature, changing the interior
lights, and activating vacation mode), the con-
trol must be awake.
To wake the display press any keypad. A confirm
tone will sound, and the current storage compart-
ment temperature will be displayed.

STARTING YOUR APPLIANCE

Display Area
Figure 10
Electronic single zone control
NOTE
Your product has an automatic defrost feature that
utilizes an electric heater element. Periodically
during defrost you may observe the following:
• Water dripping and running sounds as a
result of the frost melt
• Sizzling and popping sounds from water
dripping on the heater element
• A faint reddish glow in the freezer compart-
ment from the electric heater element
These are all "normal" operating characteristics
related to refrigeration product incorporating auto-
matic defrost. They do not represent any product
fault or safety issue.
Lock
Light
keypad
keypad
The sleep mode can be disabled if you prefer to
have the display on continuously. Press and hold
the "Lock" keypad until the display goes past "Loc"
and reads "nSL". To enable the sleep mode, repeat
the instruction, again going past "Loc" until the
display reads "SLP".
Turning your appliance ON and OFF:
If the appliance is "On", (and out of sleep mode) the
temperature will be shown in the display area of the
control. To turn the appliance "Off", press and hold
the "On/Off" keypad for 4-seconds. "OFF" will now
be displayed on the control.
To turn the appliance "On", press and hold the "On/
Off" keypad for 4-seconds.
8
System Status
indicators