HTR-2064/NS-B20/NS-C20/NS-SWP20
22. SOFT SWITCH
This menu is used to write the destination to the back-up IC (EEPROM: IC222 on DIGITAL P.C.B.).
When the following parts are replaced, the destination MUST be written by using this menu to have proper operation.
DIGITAL P.C.B.
EEPROM: IC222 on DIGITAL P.C.B.
To write the destination, first switch to the destination write mode by using the "22-1. SWITCH MODE" menu and then
select desired destination by using the "22-3. DESTINATION" menu.
22-1. SWITCH MODE
Pressing the "STRAIGHT" key will change the display alternately as shown below. When "22 SW :MODEL" is
displayed, this unit is in the destination write mode.
Note: After writing of the destination is completed, be sure to change to "22 SW :PCB".
22-2. MODEL
Not for service.
22-3. DESTINATION
Press the "STRAIGHT" key repeatedly to select desired destination. Then the selected destination is written
automatically.
Press the "STRAIGHT"
2 2 . D E S T : U
2 2 . D E S T : K
44
2 2 . S W
: P C B
Press the "STRAIGHT" key
2 2 . M O D E L : H 2 0 6 4
2 2 . D E S T : C
2 2 . D E S T : A
Destination write mode
2 2 . S W
: M O D E L
2 2 . D E S T : R
2 2 . D E S T : G
G: B, G, F models
2 2 . D E S T : T
2 2 . D E S T : L