Hdmi Audio; Speaker Set - Yamaha YHT-196 Service Manual

3. HDMI AUDIO

This menu is used to check the route of audio signal input to HDMI IN/OUT.
*
Before check using "3-3. DSD" menu, be sure to connect a CD player equipped with Direct Stream Digital output
to this unit in advance.
*
Before check using "3-4. ARC" menu, be sure to connect a TV monitor equipped with Audio Return Channel
function to this unit in advance.
3 . S P D I F
3 . M u l t i
3 . D S D
3 . A R C

4. SPEAKER SET

This menu is used to check the speaker output.
The analog switch settings for each sub-menu are as shown in the table below.
FRONT : SML 0dB
CENTER : NONE
LFE/B : FRONT
TONE : MAX
TONE : MIN
SPEAKER 6-ohms
LARGE: This mode is used for a speaker with high bass reproduction performance (a large unit). Full bandwidth
signals are output.
SMALL: This mode is used for a speaker with low bass reproduction performance (a small unit).
The signals of 90 Hz or less are mixed into the channel specified by LFE/BASS.
NONE: This mode is used for no center speaker.
The center content is reduced by 3 dB and distributed to FRONT L/R.
SWFR: LFE of 5.1 channel signal or LFE/BASS lower than 90 Hz is output through SUBWOOFER OUT.
FRONT: LFE of 5.1 channel signal or LFE/BASS lower than 90 Hz is distributed to FRONT L/R.
3-1. SPDIF
SPDIF signal is output.
3-2. Multi (DVD-Audio)
Multi signal is output.
3-3. DSD (Direct stream digital)
DSD signal is output.
3-4. ARC (Audio return channel)
The audio signal input from HDMI OUT is output.
FRONT CENTER
SMALL LARGE
LARGE NONE
LARGE SMALL
LARGE LARGE
LARGE LARGE
LARGE LARGE
HTR-2064/NS-B20/NS-C20/NS-SWP20
SURROUND SUBWOOFER
LARGE SWFR
LARGE SWFR
SMALL FRONT
LARGE SWFR
LARGE SWFR
LARGE SWFR
33