Bosch MUM 54920GB Operating Instruction page 34

en
Predetermined breaking point
The built-in predetermined breaking point
protects the drive of the appliance. If an
overload occurs, the drive shaft of the con-
tinuous-feed shredder breaks. However, the
drive shaft can easily be replaced.
A new disc holder with drive shaft is available
from customer service.
Reversible slicing disc – thick/thin
for slicing fruit and vegetables.
Process at setting 5 (3).
Designation on the reversible slicing disc: "1"
for the thick slicing side
"3" for the thin slicing side
Warning!
The reversible slicing disc is not suitable for
slicing hard cheese, bread, rolls or chocolate.
Slice boiled, waxy potatoes only when they
are cold.
Reversible shredding disc – coarse/
fine
for shredding vegetables, fruit and cheese,
except for hard cheese (e.g. Parmesan).
Processing at setting 3 (2) or 4 (3).
Designation on the reversible shredding disc:
"2" for the coarse shredding side
"4" for the fine shredding side
Warning!
The reversible shredding disc is not suitable
for shredding nuts. Shred soft cheese with
the coarse side only at setting 7 (4).
Grating disc – medium-fine
for grating raw potatoes, hard cheese
(e.g. Parmesan), cooled chocolate and nuts.
Process at setting 7 (4).
Warning!
The grating disc is not suitable for grating soft
cheese and cheese slices.
Working with the continuous-feed shredder
Fig. 
Press the Release button and move

the swivel arm to position 2.
Insert the bowl:

– Tilt the bowl forwards and then set it
down.
– Turn anti-clockwise until it locks into
place.
34
Fig.  Press the Release button and move

the swivel arm to position 3.
Remove drive cover from the drive

of the continuous-feed shredder (Fig. -
5a).
Hold disc holder at the lower end,

ensuring that the two tips are face up.
Carefully place the required slicing or

shredding disc onto the tips of the disc
holder (Fig. -6a). In the case of
reversible discs, ensure that the required
side is face up.
Grip disc holder at the upper end and

insert into the housing (Fig. -6b).
Attach the cover (note mark) and turn all

the way in a clockwise direction.
Place continuous-feed shredder on the

drive and rotate all the way in a clockwise
direction, as illustrated in Fig. -8.
Turn rotary switch to recommended

setting.
Put food to be processed in the feed tube

and push down with the pusher.
Warning!
Prevent the cut ingredients from building up
in the outlet opening.
Tip: To ensure even cutting results, process
thin ingredients in bunches.
Note: If the food to be processed sticks in the
continuous-feed shredder, switch food
processor off, pull out mains plug, wait until
the drive comes to a standstill, remove cover
from the continuous-feed shredder and
empty feed tube.
After using the appliance
Switch off the appliance with the rotary

switch.
Rotate the continuous-feed shredder in

an anti-clockwise direction and remove.
Rotate the lid in an anti-clockwise

direction and remove.
Remove disc holder with disc. To do this,

press finger from below against the drive
shaft (Fig.
Clean parts.


).
Robert Bosch Hausgeräte GmbH