Advertisement
You can select a desired phase from 0 to 359 when select 'phase'.
.
4) MOTION DET:
If you connect an alarm device to this camera, you can monitor activity more efficiently,
because a signal is generated by the camera whenever motion is detected. The motion
detection signal is output through the MD OUT Port.
1. When the SPECIAL menu screen is displayed, press the Up and Down buttons so
that the arrow indicates 'MOTION DET':
2. Set up the mode using the 4 direction buttons.
-
Sensitivity: You can select up to 8 MD areas.
-
Area Mode: Determines whether to use the MD area selected in SENSITIVITY.
-
SEL POS: Determines which of the 4 vertices of each MD area is to be used.
-
YPOS: Determines the coordinate of the vertical axis for SEL POS.
-
XPOS: Determines the coordinate of the horizontal axis for SEL POS.
-
Fill->SET: Fills in a selected MD area. The colour of filling is sequentially selected
as brown, orange, blue, cyan, yellowish green, yellow and red.
-
RETURN: Select this to save the MOTION DET menu settings and return to the
SPECIAL menu.
5) PRIVACY
This mode conceals the areas you do not wish to appear on the screen.
-
AREA SEL: You can select up to 8 MD areas.
-
AREA MODE: Determines whether to use the area selected in the AREA SEL, and
the size and position of the area.
-
MASK COLOUR: Determine area colour. You can select Gray, Green, Red, Blue,
Black and White.
-
TRANSP: Determine the transparency of selected area as controlling number from
MOTION DET.
1. SENSITIVITY
AREA1
2. AREA MODE
ON
3. SEL POS
L-TOP
4. YPOS
2
5. XPOS
3
6. FILL
SET
7. RETURN
PRIVACY
1. AREA SEL
AREA1
2. AREA MODE
ON
3. MASK COLOUR GRAY
4. TRANSP
0
5. RETURN
21
Advertisement
