Fixing The Installation Panel; Fixing The Base - Mitsubishi JT-S2AP-W-NE Installation Manual

Installation procedure (continued)

■ Fixing the installation panel

Fix the installation panel onto the wall
with 4 accessory mounting screws
(5 × 30).
The "Installation position guide" illustrated on the
●
right is recommended.
When installing on a wall, select a wall with a fl at
●
and even surface.
W h e n i n s t a l l i n g o n a c o n c r e t e wa l l , u s e
●
3
commercially available metal screw plugs.
Reinforce any walls made with materials other
●
than concrete before installation.
Recommended A measurement during installation
Space below the unit
When there are no objects below

■ Fixing the base

1. Push the power cable for exclusive
wiring through the power cord hole
at the rear of the base.
2. Engage the base with the 2 hooks on
the installation panel.
3. Check that the 2 hooks on the front
cover are hooked in the base.
4. Check that the power cable is not
4
trapped behind the base.
5. While lightly pressing the base against
the wall, fi x it with the accessory
mounting screws (5x30) (2).
To install the unit on a concrete wall, before
●
fixing the base, embed commercially available
wall plugs into the wall with the following
procedure.
① Temporarily put the base on the installation
panel.
② Mark the position of the hole in the wall
through the mounting screw hole with a pen.
③ Remove the base and embed the
commercially available wall plugs into the
marked positions.
Reinforce any walls made with materials other
●
than concrete before installation.
■ Installation position guide
Installation hole in detail
Unit (mm)
Ａ
Men 1355
Women 1255
Mounting screws (5 × 30)
(Accessories)
− 8 −
Mounting screws (5 × 30)
(Accessories)
Installation panel
10
Conduit box
Mounting hole position
below the unit
120
Power cord hole
Power cable
Panel hooks
(2 locations)
Installation
panel
Conduit box
Power cable
Power cord hole
Plug positioning
Mark the wall in
2 places
Installation panel
160
140
Unit (mm)
40
Floor
surface
140
Base
Installation
hole
Mounting screws
(5 × 30)
(Accessories)
Plugging marks
on the wall