Table of Contents
Advertisement
Installation procedure
For confi rmation
□
Single-phase 220 – 240V AC
shocks or malfunctions).
□ The ground fault circuit interrupter is attached (not attaching a ground fault circuit interrupter may result in
electric shocks).
□ The power cable has a 1.0 mm
Warning
Single-phase 220 – 240V AC
Using the incorrect power supply may cause fi res, electric shocks or
malfunctions.
Confi rm that the severing of wires
during fi xed wiring work is in
accordance with wiring regulations.
Follow the illustration on the right for the internal
●
wiring.
1
The power cable forces out the main unit and
●
does not allow proper installation if the conduit
box is not used.
NOTE
Prevent scratching on the front cover. Rust
●
may form on the scratched area.
(JT-S2AP only)
1 .Remove the front cover mounting
screw (1).
2. Disengage the tab of the upper part
of the front cover.
① Attach the installation panel to the hook of
the main unit
② Hold down the installation panel and put your
hand on the claw hook to remove the front
2
cover
3. Remove the ground wire fi xing screw
(1) from the base and remove the
front cover.
(JT-S2AP only)
power is being used (using the incorrect power supply may cause fi res, electric
2
2
to 2.5 mm
core.
power is used.
− 7 −
Do not install when the unit (power
●
cable) is electrifi ed.
Doing so may result in electric
shocks.
Conduit box
Front cover
Hook
Installation panel
Main unit
Front cover
Tab
Base
Ground wire fi xing
screw
Caution
Power cable
Unit (mm)
Front cover
mounting screw
Front cover
Claw hook
Base
Ground wire
Front cover
Advertisement
Table of Contents
