Checking After Installation; Removing The Front Cover After Installation - Mitsubishi JT-S2AP-W-NE Installation Manual

Checking after installation

When fi nishing the installation work, check the items in the table below again.
●
Be sure to solve a problem if any.
(Otherwise the expected performance and safety cannot be ensured.)
■ Points to be checked
Item
1 Wiring
2 Fixation of the main unit
3 Power supply voltage
4 Grounding
5 Setting

■ Removing the front cover after installation

NOTE
Prevent scratching on the front cover. Rust may form on the
●
scratched area.
(JT-S2AP only)
1
Remove the front cover mounting screw (1) on
the bottom of the main unit.
2
Insert a thin stick or the like into near the tab of
the upper part of the front cover and disengage
the tab.
3
Remove the ground wire fi xing screw (1) from
the base and remove the front cover.
(JT-S2AP only)
4
Perform checking after installation.
Check the "Points to be checked".
●
5
After inspection, attach the front cover in the
reverse order.
Check that the wiring conforms to the extension rules of the technical standards for electrical
equipment.
(If not, fi re may occur.)
Check that the main unit is securely fi xed on a strong surface.
(If not, personal injury may occur or the product may fail.)
Check that the voltage is 220 - 240 VAC.
(If not, the product may fail.)
Check that JT-S2AP is securely grounded.
(If not, the product may malfunction or fail.)
Check that the setting is correct.
Customer is not allowed to change the setting. Be sure to check the operation if the initial
setting is changed.
The initial setting is heater "ON" and air speed "HIGH".
− 13 −
Description
Front
cover
Base
Tab
②
Check
Front cover
Front cover
①
mounting screw
Front cover
Ground wire
Ground wire fi xing screw