2 INSTALLATION OVERVIEW
2.1 Introduction
This section provides the equipment information for installing the Flight Stream and related optional
accessories. Installation of the Flight Stream should follow the data detailed in this manual. Cabling is
typically fabricated by the installing agency to fit each particular aircraft. Always follow acceptable
avionics installation practices per advisory circulars AC 43.13-1B and AC 43.13-2B or later FAA
approved revisions.
2.1.1 Unit Configurations
The Flight Stream is available with the following part numbers.
Model
Flight Stream 110
Flight Stream 210
Connector Kit
2.2 Installation Material Required but Not Supplied
The Flight Stream units are intended for use with standard aviation accessories. The following items are
required for installation but not supplied:
Wire (MIL-W-22759/16 or MIL-W-22759/18 or equivalent). If MIL-W-22759/18 wire is utilized,
extra care must be taken to adequately support and protect the wiring due to its thinner insulation.
Shielded Wire (MIL-C-27500 cable utilizing M22759/18 wire (TG) or ETFE jacket (14), or
equivalent).
Aircraft hardware for installation, including #6 screws, nuts/nutplates, washers, and rivets
Push/Pull (manually resettable) Circuit Breaker
Tie Wraps or Lacing Cord
Ring Terminals (MS25036 or equivalent)
Shield Terminators (MIL-S-83519 or equivalent)
Silicon Fusion Tape (Garmin P/N 249-00114-00 or equivalent)
Compatible portable electronic device (PED)
Garmin Pilot™ App
190-01700-00
Rev. B
Table 2-1. Units and Part Numbers
Unit P/N
011-03257-00
011-03257-40
011-03258-00
Flight Stream 110/210 TSO Installation Manual
Unit Only
010-01194-00
010-01194-40
N/A
Kit P/N
010-01194-01
010-01194-41
N/A
Page 2-1