Figure 3-5. Mounting Orientation - Garmin Flight Stream 110/210 Installation Manual

3.3.2 Flight Stream 210 with AHRS
The Flight Stream 210 contains an attitude and heading sensor so it must be mounted rigidly to the aircraft
primary structure where vibration is minimized. Do not use shock mounting. Mounting in a vibration prone
area may result in degraded accuracy. The Flight Stream can be mounted in any direction up to 180
degrees on the roll axis and up to and including 45 degrees from centerline for the pitch axis
see figure 3-5 and figure 3-6 for details. The Flight Stream may be mounted offset from the aircraft center
line but must be mounted with the connector pointed in the direction of flight to within 3 degrees of the
yaw axis. The arrow symbol on the side of the unit points in the direction of flight. Failure to mount the
Flight Stream with the connector pointed in the direction of flight will result in an AHRS error.
NOTE
Errors less than 45 degrees in the pitch axis and less than 180 degrees in the roll axis can
be zeroed out using the application cage function on the connected portable electronic
device (PED). Errors in the yaw axis cannot be zeroed out.
190-01700-00
Rev. B

Figure 3-5. Mounting Orientation

Roll Axis
Flight Stream 110/210 TSO Installation Manual
Page 3-7