Mounting The Camera - D-Link DCS-935L Quick Install Manual

Hd wi-fi camera

Hide thumbs Also See for DCS-935L:

Please refer to the steps below to assist you with mounting the camera.

We suggest that you configure the camera before mounting.

1. Use a pencil to mark two points on the wall or

ceiling that are 40 mm (1.6 in) apart. Use a 6 mm

drill bit to drill the holes where you marked.

The holes should be 25 mm deep (about 1 in

deep). Insert the screws into the holes. When

you tighten the screws, leave 2 mm for fitting

the mounting base over the screw-heads.

Note: If the wall is made out of concrete, before inserting the screws, insert

the provided plastic anchors to support the screws.

2. Place the mounting base over the screws that

are inserted in the wall or ceiling. Make sure to

fit the screw-heads over the big holes in the

base, and slide the mounting base downward

to lock it firmly in place. Lightly pull the base

forward to make sure that it is locked. Adjust

the angle of the camera as needed.

Mounting the Camera

Table of Contents