Setting The Clock - Sony LBT-XGV10AV Operating Manual

Setting up the speakers for Dolby Pro
Logic (continued)
3
From your listening position, adjust the
volume until the volume level of the
test tone from each speaker sounds the
same.
To adjust
the volume of the
center speaker
the volume of the rear
speakers
4
From your listening position, adjust the
balance.
To adjust
the balance between
the front left and
front right speakers
the balance between
the rear left and rear
right speakers
5
Press TEST TONE when you are done
adjusting.
The test tone is turned off.
Tip
If you turn VOLUME (or press VOL+ or – on the
remote) all the speaker volume changes.
Note
The test tone feature works only for Dolby Pro Logic
Surround sound.
GB
10
Press
CENTER LEVEL +/– on
the remote.
REAR LEVEL +/– on the
remote.
Press
T or t while "LEFT",
"CENTER", or "RIGHT"
appears.
T or t while "REAR"
appears.

Setting the clock

1
Turn on the system.
2
Press c/CLOCK SET (or CLOCK/TIMER
SET on the remote).
3
Press R/r repeatedly to set the hour.
4
Press ENTER.
The minute indication flashes.
5
Press R/r repeatedly to set the minute.
6
Press ENTER.
The clock starts working.
If you make a mistake
Press T/t repeatedly until the incorrect item
flashes, then set it again.
To adjust the clock
1
Press c/CLOCK SET (or CLOCK/TIMER
SET on the remote).
2
Press R/r to select "CLOCK SET," then
press ENTER.
3
Do the same procedures as step 3 to 6
above.
Notes
• The clock settings are canceled when you
disconnect the power cord or if a power failure
occurs.
• You cannot set the clock in the Power Saving
Mode.