Diagrams - Sony HCD-EC59 Service Manual

Hide thumbs Also See for HCD-EC59:
Table of Contents

Advertisement

HCD-EC59
THIS NOTE IS COMMON FOR PRINTED WIRING BOARDS AND SCHEMATIC DIAGRAMS.
(In addition to this, the necessary note is printed in each block.)
For Printed Wiring Boards.
Note:
• X : parts extracted from the component side.
• Y : parts extracted from the conductor side.
W : indicates side identifi ed with part number.
: Pattern from the side which enables seeing.
(The other layers' patterns are not indicated.)
Caution:
Pattern face side:
Parts on the pattern face side seen
(Conductor Side)
from the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(Component Side)
the parts face are indicated.
Caution:
Pattern face side:
Parts on the pattern face side seen
(SIDE B)
from the pattern face are indicated.
Parts face side:
Parts on the parts face side seen from
(SIDE A)
the parts face are indicated.
• Indication of transistor.
C
Q
These are omitted.
B
E
Q
B
C E
These are omitted.
• Abbreviation
AR
: Argentina model
E2
: 120V AC area in E model
E4
: African model
E51
: Chilean and Peruvian models
MX
: Mexican model
14
SECTION 5

DIAGRAMS

For Schematic Diagrams.
Note:
• All capacitors are in μF unless otherwise noted. (p: pF) 50
WV or less are not indicated except for electrolytics and
tantalums.
• All resistors are in Ω and 1/4 W or less unless otherwise
specifi ed.
: internal component.
f
• 2 : nonfl ammable resistor.
• C : panel designation.
Note: The components identifi ed by mark 0 or dotted
line with mark 0 are critical for safety.
Replace only with part number specifi ed.
• A : B+ Line.
• B : B– Line.
• Voltages and waveforms are dc with respect to ground
under no-signal (detuned) conditions.
– BD74UR Board –
no mark : CD PLAY
– Other Boards –
no mark : TUNER (FM/AM)
• Voltages are taken with VOM (Input impedance 10 MΩ).
Voltage variations may be noted due to normal production
tolerances.
• Waveforms are taken with a oscilloscope.
Voltage variations may be noted due to normal production
tolerances.
• Circled numbers refer to waveforms.
• Signal path.
: TUNER (FM/AM)
F
: CD PLAY
J
: USB
E
: PC IN
f
• Abbreviation
AR
: Argentina model
E2
: 120V AC area in E model
E4
: African model
E51
: Chilean and Peruvian models
MX
: Mexican model

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents