Maintenance; Cleaning; Cleaning The Cabinet; Cleaning The Lens - Philips bClever SV1 User Manual

Philips multimedia projector user manual
Hide thumbs Also See for bClever SV1:
Table of Contents

Advertisement

Cleaning

Caution
MENU
MENU
OK
OK
VOLUME +
VOLUME +
PICTURE SIZE –
PICTURE SIZE –
PICTURE SIZE +
PICTURE SIZE +
VOLUME –
VOLUME –
DATA
S-VIDEO
VIDEO
STANDBY
SOURCE
AV MUTE
SOURCE
Important
DATA
S-VIDEO
VIDEO
FILTER
A
A
DATA
S-VIDEO
VIDEO
FILTER
Notes
Philips Multimedia Projector

6. Maintenance

Switch off and disconnect the projector before cleaning.
y
Press the
Standby button twice to switch off the projector.
1
The Standby indicator starts blinking red.
Wait until the cooling fan has stopped (about 3 minutes after the projector has been put in
2
Standby) and disconnect the mains lead and all other cables.

Cleaning the cabinet

When the cabinet is dusty, clean it by gently wiping with a soft cloth.
A chamois leather slightly moistened with water is sufficient for cleaning the housing.
Do not use cleaning agents as they may harm the housing.

Cleaning the lens

When the lens is dirty or dusty, first blow the dust off and then gently wipe with a soft
brush or lens cleaning paper. Never touch the lens with your fingers.
The lens is likely to become mouldy if left dirty.

Cleaning the dust filter

Make sure to clean the dust filter regularly.
Switch off the projector and wait until the cooling fan has stopped before disconnecting the
1
projector.
Remove the filter holder from the projector.
2
AUDIO-L
AUDIO-R
Press clamp A, open the holder and remove the filter.
3
While firmly holding the filter, gently remove any accumulated dust, from the dusty side, with
4
a vacuum cleaner.
Press clamp A, put the filter back in place and release clamp A. Firmly press the filter edges
5
in place.
Close the filter holder.
6
Insert the filter holder into the projector until it clicks in position.
7
AUDIO-L
AUDIO-R
We advise you to clean the filter every 100 hours. Operating the projector without filter or with a torn
or damaged filter may seriously damage the projector.
When the filter is damaged replace it with a filter of the same type (12 nc: 3122 434 02190).
Don't switch on the projector again unless the filter holder is installed correctly.
31
English User guide bClever SV1
>

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents