Starting Operation - Bosch PSM 80 A Operating Instructions Manual

Hide thumbs Also See for PSM 80 A:

Original instructions manual (88 pages)

Instructions manual (69 pages)

Original instructions manual (60 pages)

Table Of Contents

Table of Contents

Available languages

OBJ_BUCH-2 609 001 518-001.book Page 4 Monday, February 27, 2006 9:58 AM

Replacing the Sanding Sheet

(see figure C)

B Before any work on the machine itself, pull

the mains plug.

When attaching a new sanding sheet, remove any dust

or debris from the sanding plate 3 (e. g. with a brush).

To ensure optimum dust extraction, pay attention that

the punched holes in the sanding sheet match with the

holes in the sanding plate.

The sanding plate 3 is fitted with Velcro backing for

quick and easy fastening of sanding sheets with Velcro

adhesion.

Before attaching the sanding sheet 4, free the Velcro

backing of the sanding plate 3 from any debris by tap-

ping against it in order to enable optimum adhesion.

The machine is fitted with 2 sanding sheets that can be

changed individually, depending on the degree of wear.

B Only use the machine when both sanding

sheets are mounted.

B Only use sanding sheets with the same grain

size.

Position the sanding sheet 4 flush alongside one edge

of the sanding plate 3, then lay the sanding sheet onto

the sanding plate and press it against it with a light turn-

ing motion in clockwise direction.

To remove the sanding sheet 4, grasp it at one of the

tips and pull it off from the sanding plate 3.

Sanding sheets of the Bosch Delta Sander can be

used.

Sanding accessories, such as fleece pads/polishing

cloth pads, are attached to the sanding plate in the

same manner.

2 609 001 518 • 27.2.06

Selecting the Sanding Sheet

Depending on the material to be worked and the

required rate of material removal, different sanding

sheets are available:

For the working of all wooden

materials

For coarse-sanding, e. g. of rough,

unplaned beams and boards

For face sanding and planing

small irregularities

For finish and fine sanding of hard

woods

For the working of paint/

enamel coats or primers and

fillers

For sanding off paint

For sanding primer

For final sanding of primers before

coating

For reworking or polishing, especially of metal and

stone, use fleece/polishing cloth pad.

Depending on the desired surface quality of the work-

piece, different fleece types or polishing cloth pads are

to be used.

Operation