Linking The Drivers - SBIG STX Series Operating Manual

Do not update your firmware unless instructed by support staff.

Linking the Drivers

Once the Camera Drivers have been installed they need to be linked to the camera by
Windows. Follow the instructions below to link your Drivers to the Camera.
• First off, Windows can be finicky when it comes to linking the drivers. If you have
any questions or problems with this procedure go back to the CD-ROM and read
the Application Note which is available through a button where you Installed the
Driver Checker.
• Power up the camera. The LEDs on the side should blink momentarily and the
Fan should come on. This indicates the camera has completed its internal power-
on boot-up sequence.
• Connect the Camera to your computer with the supplied USB cable. Windows
will detect the Camera and bring up the Add New Hardware Wizard.
• The Wizard will ask you if you want to check for updated drivers. Select No, not
this time then click Next.
• The Wizard will ask how you want to install the software (link the drivers).
Select Install the software automatically then click Next.
• Follow the onscreen instructions to complete linking the drivers to your camera.
At this point you could open the Device Manager and verify that you should see
an entry for the SBIG Camera.
21