Drive Auto Adjustment - Sony DVP-CX860 Service Manual

6-4. DRIVE AUTO ADJUSTMENT

On the Test Mode Menu screen, press
mander, and the drive auto adjustment menu will be displayed.
## Drive Auto Adjustment ##
Adjustment Menu
0. ALL
1. DVD-SL
2. CD
3. DVD-DL
4. SACD
Exit: RETURN
[0]
Normally, is selected to adjust DVD (single layer), CD, DVD
(dual layer), and SACD in this order. But, individual items can be
adjusted for the case where adjustment is suspended due to an
error. In this mode, the adjustment can be made easily through the
operation following the message displayed on the screen.
The disc used for adjustment must be the one specified for adjust-
ment. However, for SACD disc, use the player with initial data if
the disc is not available.
0. ALL
[0.ALL]
When is selected, set the three discs at the same time.
With the signal read out side of disc facing to the left, set the discs
into 1. DVD-DL, 2. CD, 3. DVD-DL starting from number 1 of
[ENTER]
the T.table in this order. Press
2. CD disc and 3. DVD-DL disc are adjusted in this order. Discs
need not be replaced. If an error is detected, re-start the adjust-
ment from the very beginning. When you want to adjust these discs
one disc after another, set the T table number to 1. Each time one
disc was adjusted, it is ejected. Replace it with the specified disc
following the message. Though the message to confirm whether
discs other than SACD disc are adjusted is not displayed, you can
finish the adjustment if pressing the
level, RF level, and jitter value can be confirmed during adjust-
[ENTER]
ment, and if OK, press the
[STOP]
(If NG, press the button) During adjustment of each disc,
the measurement for disc type judgment is made. As automatic
adjustment does not judge the disc type unlike conventional mod-
els, take care not to insert wrong type discs. Also, do not give a
shock during adjustment.
[1]
key on the remote com-
. Then, 1. DVD-SL disc,
[STOP]
button. The S curve
key and continue adjustment.
6-5
1. DVD-SL (single layer)
[1]
Select , insert DVD single layer disc, and press
and the adjustment will be made through the following steps, then
adjusted values will be written to the EEPROM.
DVD Single Layer Disc Adjustment Steps
1. SLED TILT Reset
2. Disc Check Memory SL
3. Wait 500 msec
4. Set Disc Type SL
5. LD ON
6. Spdl Start
7. Wait 1 sec
8. Focus Search ON
9. Focus Search OFF
10. Focus Servo ON 1
11. Auto Track Offset Adjust
12. Tracking ON
13. CLVA ON
14. Wait 1 sec
15. Sled ON
16. Check CLV Lock
17. Auto LFO Adjust
18. Auto Focus Offset Adjust
19. Auto Tilt Position Adjust
20. Auto Focus Gain Adjust
21. Auto Focus Offset Adjust
22. EQ Boost Adjust
23. Auto LFO Adjust
24. Auto Track Gain Adjust
25. All Servo Stop
26. Eep Copy Loop Filter Offset
[ENTER]
key,