Installing The Camera Under Windows 98Se / Me; Additional Installation Information Using Windows 98Se / Me - AIPTEK PenCam Pilot Manual

Table of Contents

Advertisement

Installing the Camera under Windows 98SE /
To start the camera installation, connect the Mini PenCam to the computer.
Use the USB cable provided.
Note: Insure that the camera is turned off before connecting it to the USB -
Cable.
Connect the smaller end of the USB -Cable to the USB-connection port of
the camera. Connect the larger end of the USB-Cable to a free USB-Port
located on the back of the computer
Windows should automatically recognize the newly attached hardware and
launch the Hardware assistant.
The Hardware-Assistant will automatically look for drivers and integrate the
components into the system.
The Driver consists of three components which windows will install one
after the other:
Capture devices:
Mega Camera, WDM Image Capture
USB-Controller:
Mega Camera, WDM DSC I/O Driver
USB-Device or MegaCamera USB Camera
The installation is complete when all three driver-components have been
properly installed. The camera can now be used.
- Page 17 -
ME

Additional Installation Information using Windows 98SE / ME

After proper installation of the drivers, the three components can be found in
the device manager
Select the device marked with a "!" or "?" and press the "delete" button.
Confirm you action by pressing "OK". You will then be instructed to reboot
the computer. Press "OK" to reboot now or "cancel" to reboot at a later time.
Uninstall the Mega Camera Manager: Click on Start → Programs → Mega
Camera Manager → Uninstall Mega Camera Manager.
Disconnect the USB cable from the camera and reboot the computer. After
the computer has rebooted, reinstall the Mega Camera Manager.
- Page 18 -
Device Manager:
To find the Device Manager click on:
Start → Control Panel → System →
Device Manager
If
for
some
reason
the
driver
installation has failed or windows
could not recognize the camera, a
yellow circle with an "!" or "?" will
appear before the device entry.
Refreshing the driver using Windows
98SE/ME is not possible. Because of
this the driver must be completely
removed and reinstalled.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Pencam plusMini pencam plus

Table of Contents