HP MSR Series Configuration Manual page 23
Hide thumbs
Also See for MSR Series:
- Configuration manual (889 pages) ,
- Command reference manual (684 pages) ,
- Wan access configuration manual (293 pages)
Table of Contents
Advertisement
Configure the available bandwidth used for setting the thresholds and the enable-threshold and
disable-threshold of load balancing.
Figure 8 Network diagram
Configuration procedure
1.
Configure IP addresses:
Follow
shown.)
2.
Configure a static route:
# On Router A, configure a static route to the segment 192.168.2.0/24 where Host B resides.
<RouterA> system-view
[RouterA] ip route-static 192.168.2.0 24 serial 2/0
[RouterA] ip route-static 192.168.2.0 24 serial 2/1
[RouterA] ip route-static 192.168.2.0 24 serial 2/2
# On Router B, configure a static route to the segment 192.168.1.0/24 where Host A resides.
<RouterB> system-view
[RouterB] ip route-static 192.168.1.0 24 serial 2/0
[RouterB] ip route-static 192.168.1.0 24 serial 2/1
[RouterB] ip route-static 192.168.1.0 24 serial 2/2
3.
Disable the fast forwarding function:
# Disable the fast forwarding function on interfaces Serial 2/0, Serial 2/2, and Serial 2/2 on
Router A.
[RouterA] interface serial 2/0
[RouterA-Serial2/0] undo ip fast-forwarding
[RouterA-Serial2/0] quit
[RouterA] interface serial 2/1
[RouterA-Serial2/1] undo ip fast-forwarding
[RouterA-Serial2/1] quit
[RouterA] interface serial 2/2
[RouterA-Serial2/2] undo ip fast-forwarding
[RouterA-Serial2/2] quit
# Disable the fast forwarding function on interfaces Serial 2/0, Serial 2/2, and Serial 2/2 on
Router B.
[RouterB] interface serial 2/0
[RouterB-Serial2/0] undo ip fast-forwarding
Figure 8
to configure the IP address and subnet mask for each interface. (Details not
19
Advertisement
Table of Contents
