Mounting On A Vesa Arm - GE IC754VSI06STD Datasheet

Chapter 4. Installation
3. Verify that the gasket is in the bezel channel located on the sides of the QuickPanel+.
4. Insert the hook of the mounting bracket into the mounting hole as shown below.
5. Tighten the screws on the mounting bracket in the clock-wise direction.
Note: The torque range for the mounting clamp screws is (0.3 Nm).
4.4

Mounting on a VESA Arm

The QuickPanel+ can be installed on a commercially available Video Electronics Standards
Association (VESA) MIS-D 75mm arm. To mount the QuickPanel+, use the mounting holes
located on the back of the unit. The mounting holes are 75mm (2.95 inches) apart and attach
with M4 screws that are 6mm (0.24 inches) or less in diameter.
Note: The torque range for the mounting M4 screws is (0.7 – 0.8 Nm). Refer
to the mounting arm manual for instructions.
QuickPanel+ User's Manual–November 2013
GFK-2847 21