Cruise Control; Engine Brake - MCi J4500 Operator's Manual

CRUISE CONTROL

Do not use cruise control in heavy traffic, on
icy roads or in any other driving condition
that does not permit a constant speed.
Setting Vehicle Speed
Press the switch to turn on the cruise control.
ON
Accelerate to the desired speed, press the Set
switch, then release the accelerator pedal. The
CRUISE ENABLED telltale on the RH cluster stays
on until the cruise control is turned off.
Cruise control will not operate under 20 mph
(32 km/h).
Increasing Set Speed
1. Press and hold the
speed is reached, or,
2. Press the accelerator pedal until the desired
speed is reached, then press and release the
switch.
When driving with cruise control, speed may
be increased (for passing, etc.) by pressing
the accelerator in the usual way. Releasing
the accelerator returns the coach to the set
.
speed
Decreasing Set Speed
1. Press and hold the
speed is reached, or,
2. Lightly press the brake to disengage the
system. Allow the vehicle to coast to the desired
speed, then press and release the
The transmission may be shifted in the
normal way without disengaging the cruise
control.
Canceling the Set Speed
1. Press the switch or the
OFF
2. Make a slight brake application.
June 2016
switch until the desired
RES
SET
switch until the desired
SET
switch.
SET
button, or,
CANCEL
NOTE: When automatic operation is canceled,
may be used to return to cruise control.
RES
Figure 27. Switch Pod

ENGINE BRAKE

The engine brake controls are mounted on the RH
side of the steering wheel.
The four controls are: OFF, LOW, MEDIUM and
HIGH.
Figure 28. Switch Pod
The button located at the top of the RH control
features a "courtesy light" that momentary flashes
the coach marker lights to acknowledge passing
vehicles.
27