Table of Contents
Advertisement
INSTALLATION
Remove and discard cantilever shelf packing
clips located just above each shelf where it hooks
onto the frame. To remove plastic clips, wiggle
TURN CLOCKWISE
TO
the clips sideways and
ptlll
straight out.
LOWER CABINET CORNER
Locating
Your Refrigerator
1. Allow a free flow of air thro,lgh tile front base
grille.
TURN
2,
Yonr
model
should
not
be
inse_dled
where
the
COUNTER-
room temperature will go below 5,5 degrees
CLOCKWISE
TO
RAISE
CABINET
F., because it will not run frequently enough
CORNER
to maintain proper telnperature
in the freezer.
--"
3. For ease of'instaIiation, you should leave a
3. It is not necessary to lock the refrigerator in
space of about 1/2 inch between the
place. However, if that is desirable, turn one
refrigerator and adjacent walls or cabinets. If
or both of the locking feet clockwise. They are
the refrigerator is placed with tlle hinge side
located near the front wheels.
against a wall, you may want to leave
If the floor is not level and it is neeessau to
additional space so the door can be opened
raise the rear of the cabinet, we suggest
wider,
rolling the rear wheels onto a piece of
plywood or other shim material.
Important
Leveling
Information
4. To replace, center the clips in the cut-out
areas and push in until the base grille snaps
Your ret}igerator is equipped with front and back
into place.
rollers so it can be moved away from the \vail for
cleaning. The front rollers are acljustable and
Connecting
the Appliance
should he positioned so the refrigerator sits
firmly on the floor and is level.
WARNING:
This appliance is designed to
operate on a nominal 115 volt, 15 amp, 60 cycle
To adjust
the front
rollers:
line. There should be a separate, grounded
1. Remove the base grille by grasping the ends,
cireuit serving this appliance only: Do not use an
lift and pull out.
extension cord.
This appliance is equipped with a three-pronged
grounding plug for your protection against
possible electrical shock hazards. It must be
plugged into a grounding receptacle. Where a
E
_
standard two-prong wall receptacle is
_
_
encountered,
it is the personal responsibility and
obligation of the customer to have it replaced
with a properly grounded three-prong wall
2. To level the refrigerator, nse a screwdriver
receptacle. Do not under any circumstances, cut
and turn roller adjusting screws clockwise to
or remove the third (ground) prong f?om the
lower the cabinet or eounterclockwise to raise
the cabinet,
power cord. Do not use an adapter plug,
PAGE 2
Hide quick links:
Advertisement
Table of Contents
