HIOS CLT-AY-61 Operation Manual page 5

● Rear Panel (Terminal location of CLY-AY-81 is different from CLT-AY-61 but same function)
Terminal ：Connect Input and/or Output cables.
Terminal is removable by unscrewing 2 screws at the both end of the terminal.
When you do it, unscrew each of screw little by little.
The table below is the status of switches of the PCB set at HIOS factory.
If you change the setting, refer to the section of "Input/Output setting"
Fuse Holder : 1 each of Fuse and Spare Fuse are installed.
If the Fuse is cut then the lamp of AC Switch and LED lamps do not lit,
replace with Spare Fuse.
4