Name Of Each Part - HIOS CLT-AY-61 Operation Manual

Name of Each Part

● Front Panel (CLT-AY-81 is similar to CLT-AY-61)
Main Switch: ON and OFF AC100, 120V or 220 - 240V Power with is brought to Transformer.
Function Leeds:
START : This lamp turns on while the START signal is input.
PLAYING : This lamp turns on while the START driver rotates.
CL PULSE : This lamp indicates that the pulse signal output when the torque detection SW of
driver detects the torque. The rotation of diver will also be stopped by this pulse
signal provided to the transformer.
FINISH : This lamp turns on when the screw tightening is finished. And it keeps lighting until
the next starting or reset command is executed.
RESET : This lamp turns on while any trouble is occurred on tightening or overtime condition.
*Note; In case that output circuit is short or load is over, CL PULSE and RESET LEDs turn on
simultaneously and output to the motor of driver will be stopped. In such case, check
the driver.
OPTIONS (Followings are optional specifications.)
2WV : This lamp turns on while the driver works at Low Level of rotation, described at the
optional LOW-HI specifications.
REV : This lamp turns on while the driver works at Reverse rotation, described at the optional
REV specifications.
COUNTER SW : Number of the impact for completion of tightening is selected
By this SW; 1= 1 time of impact
Voltage Adjusting
Dial : You can adjust the times of rotation steplessly in a provided range.
Circuit Breaker : This protects the secondary side (driver, circuit) of transformer.
2= 2 time of impact
3= 3 time of impact
3