Kenwood DDX7051BT Instruction Manual page 80

CONNECTION/INSTALLATION CONNECTION/INSTALLATION
❏ Connecting wires to terminals for DDX7051BT/DDX517BT
10 A fuse
See page 83.
See page 83.
See page 83.
See page 84.
1
White ª / White with black stripe · : To front speaker (left)
Gray ª / Gray with black stripe · : To front speaker (right)
Green ª / Green with black stripe · : To rear speaker (left)
Purple ª / Purple with black stripe · : To rear speaker (right)
Light blue with yellow stripe (Steering remote control wire)
Brown (Mute control wire)
Blue with white stripe (Power control wire/Antenna control wire) (12 V
Orange with white stripe (Dimmer control wire)
Red (Ignition wire)
Yellow (Battery wire)
Black (Ground wire)
80
See page 83.
Purple with white stripe (Reverse sensor wire)
Light green (Parking sensor wire)
USB terminal (1.0 m): See page 82.
See page 83.
REAR VIEW CAMERA
See page 83.
VIDEO OUT
*
350 mA)
Connect the antenna cord to the antenna terminal.
To the remote adapter (not supplied) which is compatible with your car.
Not used.
To the power control terminal when using the optional power amplifier.
(Or)
To the control terminal of the motor antenna or to the power terminal for the
booster amplifier of film-type antenna.
To car light control switch.
To car chassis
* If no connections are made, do not let the cable come
out from the tab.
Connect to the vehicle's reverse lamp harness
when using the optional rear view camera.
Connect to the vehicle's
3
parking brake detection
switch harness.
• For best safety, be sure
to connect the parking
sensor.
Ignition key switch
Fuse box
Battery