Rowenta SILENCE STEAM User Manual page 12

Brown streaks come through the holes in the
soleplate and stain the linen.
The soleplate is dirty or brown and may stain
the linen.
There is no steam.
There is little steam.
Water streaks appear on the linen.
The "empty tank" signal light is flashing.
Steam escapes from the scale collector
valve.
Steam escapes under the appliance.
The "Calc-Away" light is flashing.
The red "tank empty" light is flashing and
the "On/Off" button is not working.
If you have any product problems or queries with your product, please telephone our Customer Relations team
on:
0345 602 1454 (UK) - (01) 677 4003 (ROI)
You are using chemical descaling agents or
additives in the water for ironing.
Fabric fibres have accumulated in the holes
of the soleplate and are burning.
Your linen is not rinsed sufficiently or you
have ironed a new garment before washing
it.
You are not using the correct programme for
the fabric.
You are using starch.
The tank has not been fitted correctly into its
housing.
The water tank is empty (red light is flashing).
The soleplate temperature is set to the
maximum.
The steam output control dial is set at
minimum.
Your ironing board cover is soaked with water
because it is not suited to the power of a
steam generator.
You have not pressed the "empty tank" restart
button.
The tank is not correctly fitted in its housing.
The scale collector valve has not been
tightened correctly.
The scale collector valve is damaged.
The generator is faulty.
The generator is faulty.
You have not pressed the "Calc-Away"
restart button.
The appliance has been stored in a cold
place (approx. <10C°)
Never add this type of product in the water
tank or in the boiler.
Clean the soleplate with a non-metallic
sponge. Vacuum the holes from time to time.
Ensure linen is rinsed thoroughly to remove
any soap deposits or chemicals on new
garments which may be sucked up by the
iron.
See our advice about "regulation".
Always spray starch on the reverse side of the
fabric to be ironed.
Push it back into its housing until you hear a
"click".
Fill the water tank and press the "Restart"
button on the control panel.
The generator is working but steam is very hot
and dry. As a consequence, it is less visible.
Increase the steam output (control dial on
the control panel).
Check that your ironing board is suitable. A
mesh type ironing board must be used avoid
condensation.
Press the "empty tank" restart button on the
control panel.
Push it into the housing until you hear a
"click".
Tighten the collector valve.
Contact an Approved Service Centre.
Do not use the steam generator and
contact an Approved Service Centre.
Do not use the steam generator and
contact an Approved Service Centre.
Press the "Calc-Away" restart button
located on the control panel.
Unplug the appliance. Wait for 3 hours so
that the appliance is at room temperature
Consult our web site: www.rowenta.co.uk