Self Diagnosis - Sony KDL-40V4000 Service Manual

The identification of errors within the EG1L-L chassis is triggered in one of two ways :- 1: Busy or 2: Device failure to respond to IIC. In the
event of one of these situations arising the software will first try to release the bus if busy (Failure to do so will report with a continuous
flashing LED) and then communicate with each device in turn to establish if a device is faulty. If a device is found to be faulty the relevant
device number will be displayed through the LED (Series of flashes which must be counted).
LED Error Codes and Descriptions
Number of LED
Flashes
02 DC_DET (12V main voltage).
06
07 Internal temperature error.
08 Audio error (SP protection).
10
11
12
13
14
15
16 I2C CH1 (VERD TAS).
17 I2C CH0 (VERD NVM/RTC).
21
22
EG1L-L SELF DIAGNOSTIC SOFTWARE
Error Description
Panel Det error.
Digital error.
NVM error.
I2C error VCT.
Balancer error.
HDMI error.
Tuner Error
VCT error
MSP error.
Micro Checked
VERD In normal mode.
VERD In normal mode.
VERD In normal mode.
VERD In normal mode.
VCT In normal mode.
VCT In initialisation state.
VCT In normal mode.
VERD In normal mode.
VCT In initialisation state.
VCT In initialisation state.
VERD Factory mode.
VERD Factory mode.
VERD In normal mode.
VCT In initialisation state.
- 8 -
Action
Goes into standby and LED flashes.
Goes into standby and LED flashes.
Goes into standby and LED flashes.
Goes into standby and LED flashes.
Adds error to error menu.
Adds error to error menu.
Adds error to error menu.
Goes into standby and LED flashes.
Adds error to error menu.
Adds error to error menu.
LED error.
LED error.
LED error.
Adds error to error menu.